Shakesby ET1865 Iron Removal Filter

Shakesby ET1865 Iron Removal Filter
Views: 13321 Brand: Shakesby
Product Code: ET1865
Availability: Pre-Order
Product Brochureclick to download pdf
There are 0 products sold.
£0.00 Ex Tax: £0.00
Qty: Add to Cart

Shakesby ET1865 Iron Removal Filter​

The Shakesby ET range of iron removal filters suit all sizes of domestic properties and small industrial sites, treating all the water from a borehole pump.  They continually aerate the water in service and use air and water to backwash.  This means they can cope with higher iron and hydrogen sulphide (rotten egg smell) levels, higher flow rates and use about half the service flow rate to backwash.  As fully intergrated filters they contain all the aerating and venting components.

  • System - treats all water from source pump to storage or point of use
  • Iron level - up to 30000ug/l (30mg/l) depending on site conditions
  • Filter media: SIRM
  • Backwash frequency 2-7 days dependant on site conditions
  • Backwash flow rate - 1.1m3/hr
  • Maximum flow rate - 2.5 m3/hr
  • Dimensions H x W (m) - 2.01 x 0.48
  • Supply pressure - min 2 bar  max 4 bar
  • All flow rates approximate

All Shakesby units come with a 1 year guarantee on the condition that the filters are installed by an approved Shakesby Distributor.

The Shakesby range is a specialist product requiring installation by an approved distributor.  For further information and advice on product selection, please contact us.

buy online with DealsPolo.com

There are no reviews for this product.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: