Shakesby ET1665 Iron Removal Filter

Shakesby ET1665 Iron Removal Filter
Views: 13112 Brand: Shakesby
Product Code: ET1665
Availability: Pre-Order
Product Brochureclick to download pdf
There are 0 products sold.
£0.00 Ex Tax: £0.00
Qty: Add to Cart

Shakesby ET1665 Iron Removal Filter​

The Shakesby ET range of iron removal filters suit all sizes of domestic properties and small industrial sites, treating all the water from a borehole pump.  They continually aerate the water in service and use air and water to backwash.  This means they can cope with higher iron and hydrogen sulphide (rotten egg smell) levels, higher flow rates and use about half the service flow rate to backwash.  As fully interated filters they contain all the aerating and venting components.

  • System - treats all water from source pump to storage or point of use
  • Iron level - up to 30000ug/l (30mg/l) depending on site conditons
  • Filter media - SIRM
  • Backwash frequency 2-7 days dependant on site conditions
  • Maximum flow rate - 2.0 m3/hr
  • Backwash flow rate - 0.8m3/hr
  • Dimensions H x W (m) - 1.93 x 0.48
  • Supply pressure - min 2 bar  max 4 bar
  • All flow rates approximate

All Shakesby units come with a 1 year guarantee on the condition that the filters are installed by an approved Shakesby Distributor.

The Shakesby range is a specialist product requiring installation by an approved distributor.  For further information and advice on product selection, please contact us.

buy online with DealsPolo.com

5 ( 5 / 5 )
I am so thrilled with the results after having tried filters from other manufacturers. Would certainly recommend them without any hesitations. A big thank you for your excellent service.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: